The Phenom
04-24-2011, 08:11 AM
I have a 427 aluminum block, billet crank with high ports. It has 1.6 T&D shaft rockers . I bought this motor complete only to find out that the oiling system,lifters and pushrods had been changed . Recently i installed the motor in the car and didnt have any oil to the top of the pushrod and finally found out that i had the wrong lifters in there. It has a 905 lifter bore but dont know anything else . i was told that it had a jesel aluminum ts series keyway lifter. What do i have to measure to determine what lifter i need? Thanks for the help