PDA

View Full Version : Dart Vs Edelbrock


87Bird
08-06-2011, 11:17 PM
Does anyone know the height difference beween the Edelbrock Performer manifold and the Dart Dual Plane manifolds. Also, how does the Dart compare to the RPM Performer as far as performance?

allend43
08-07-2011, 04:30 PM
Does anyone know the height difference beween the Edelbrock Performer manifold and the Dart Dual Plane manifolds. Also, how does the Dart compare to the RPM Performer as far as performance?

David Vizard did a comparison of all the performer rpm type manifolds, and if I remember right they all came witin a couple of hp of each other, but the dart beat the edelbrock by , I think it was one hp. The professional products manifold was down like two on top, but was two higher down low, so basically, do you have a coin to toss?

87Bird
08-07-2011, 04:57 PM
Lol, I didn't figure there wasn't much difference and I'm sure each will perform differently per application. I really don't want an aftermarket hood but I think this will be my only choice. The Edelbrock Performer fits just fine but the RPM Performer hits.

I guess if I end up with parts on this build that I don't use it's an excuse for another build later.