Cam wear plate?

[grpweld]

On the SHP block should you run a cam wear plate ( block protector) or leave it off? I am triing to use a jeggs timming chaing kit that has a torrington bearing built into it & can not get the cam lobes to go far enough in to center in the lifter bores. It's about .040" shy.

this is the timing set

20410 - JEGS 9-Keyway Double-Roller Billet Timing Chain Sets


help,

George

[Awesome Bill]

the lobe does not have to line up directly in the middle. The wheel is only .750. No, the torrington bearing does not need a wear plate. The bearing has its own plate so no need to put another one in there. Just as it comes is fine.