Dart Vader
03-30-2009, 12:43 PM
I've posted up an excerpt from Richard Maskin's seminar at the 2008 PRI show. It was the portion of the seminar where he discussed cylinder honing. There is some very useful information in the discussion and I thought the more hard-core enthusiasts would enjoy the segment so I posted it up.
For the casual enthusiast it may be a bit dry and technical... Let me know if you guys found it useful or informative.
Later everyone!
For the casual enthusiast it may be a bit dry and technical... Let me know if you guys found it useful or informative.
Later everyone!